Bushnell Binoculars 263230CL User Manual

NIGHT WATCH  
3 x 32  
digital night vision  
w/ Color lCd  
InstructIon  
manual  
Model #: 263230CL  
Lit. #: 98-1588/03-10  
 
Congratulations on the purchase of your Bushnell® Night Watch Digital Color Night Vision. Comprised of high quality electronics  
and optics, this Bushnell Night Watch unit is a hand-held digital night vision viewing system that utilizes a low-light charge coupled  
device (CCD) sensor providing images comparable to generation 2 & 3 resolution. Day and Night time images are magnified and  
displayed on a Color LCD micro display screen, which provides a color image when ambient light conditions are high enough,  
and a desaturated color or neutral, monochrome image (not the typical "green screen" night vision) under lower ambient  
light conditions. The Digital Color Night Vision also contains an RCA video output port which allows live transmission to video  
camcorders, computer lap tops / monitors, and television screens.  
HoW DIGItal nIGHt VIsIon WorKs  
Bushnell Digital Night Vision products collect existing light through the objective lens. The light is then processed through a highly  
sensitive CCD sensor and transferred to the micro liquid crystal display (color LCD). Images viewed on the LCD are magnified 3  
times. An infrared illuminator provides a light source to enable viewing in total darkness.  
The Bushnell Night Watch Digital Color Night Vision unit is ideal for camping, caving, scouting, maritime navigation, and observing  
wildlife under the veil of darkness, patrolling warehouses and similar surveillance operations where light is scarce.  
oPEratInG InsructIons  
1. Slide the battery compartment door (2) open in the direction of the white arrow. Insert two CR123 batteries (3v lithium, not  
included) into the battery compartment. Be sure to observe the correct battery polarity, as shown on the left. The "+" end of the  
top battery should be facing out (towards the battery door), and the "-" end of the lower battery should be facing out.  
2. Remove the front lens cover. When finished using the unit, replace the cover to protect the objective lens (1) and IR light (7).  
3. Press the ON/OFF switch (3) to power the device on. A green LED light (4) indicates that the power is on. To extend battery life, the  
unit will normally turn off automatically after 2 minutes (if no buttons are pressed). To cancel this auto-off function, briefly press  
and release the IR switch (8) on the top of the unit. The power will then remain on until you turn it off manually with the ON/OFF  
switch. The orange light on the lower half of the power indicator light (4) will glow if the unit is in auto-off mode (default), and will  
turn off if you cancel the auto-off function. If the batteries become weak, the green power indicator LED will blink.  
4. View through the eyepiece (5) and select an object to focus on.  
3
 
5. To focus the image, first rotate the eyepiece rubber ring (5) until the edges of the LCD display appear sharp to your vision. Next,  
rotate the objective lens focus wheel (6) until the object is in focus and the view is clearest. At this point, the display focus (eyepiece  
ring) is set for your individual eyesight and will not require further adjustment when viewing objects at different distances. When  
changing the viewing distance, simply rotate the main focus wheel (6) until the image is in focus.  
6. The Digital Night Vision has a light level sensor on the front of the unit (14) which detects low light conditions and automatically  
turns on an infrared illuminator (7) to improve image quality. When the IR light is on, this is indicated by the red LED (9) above the  
power indicator. You can also turn the IR illuminator on manually anytime, even if ambient light levels are high, by pressing and  
holding the IR switch (8) for a at least two seconds (when you release the switch, you will see the red IR illuminator LED indicator,  
confirming the IR illuminator is on now).  
7. To increase the brightness of the IR illuminator, press the "+" key (10). This can be used to extend your viewing distance. To decrease  
the brightness of the IR illuminator, press the "-" key. This can be helpful in improving the LCD display viewing quality (by avoiding  
"wash out") in very low light conditions or complete darkness.  
8. While moving from viewing one object to another object, it might be necessary to rotate the objective lens focus wheel and adjust  
the IR illuminator brightness in order to achieve the best image quality.  
9. The Digital Night Vision includes a video output ("TV Out") jack (13). This port allows one to transmit images to an external video  
monitor or video recorder. Plug the output video cable into the video output jack ("TV Out"). When the Digital Color Night Vision  
is connected to compatible (NTSC) video equipment, the image produced by the unit can be monitored and/or recorded.  
10. The Digital Color Night Vision also includes a 6 volt auxiliary power input jack (12). To connect the Digital Night Vision to a  
household outlet, use the included 6 volt AC power adapter. Note that this feature is not intended to recharge batteries of any type,  
and should not be used for that purpose. It simply provides an option for an external power source.  
notE: When the batteries are inserted and the external power source is turned on, the device operates on the external power  
source. If you unplug the external power source, and you want to use the battery source, you have to press the ON button (3) to  
make the device operate.  
notE: A standard tripod mounting socket is provided on the bottom of the unit. Remove the round rubber plug near the center of  
the bottom face of the unit and set it aside.  
4
 
trouBlEsHootInG  
unit will not turn on  
1. Check that the batteries are installed correctly (2). If the batteries are installed correctly and the batteries are good, then the green  
LED indicator light should be on steadily.  
2. Check that the power button (3) has been pressed.  
Power does not stay on  
1. Replace the batteries when they become weak.  
2. The unit normally turns off automatically after 2 minutes to conserve battery power. To defeat this, briefly press the IR switch.  
Image is not focused.  
1. Adjust the objective focus wheel (6) and eyepiece display focus (5).  
2. Make sure you are not too close to the object you are viewing.  
carE anD maIntEnancE  
Your Bushnell Digital Night Vision device was designed to provide many years of reliable service. To ensure that you get the most  
enjoyment out of your Digital Night Vision device, always obey the following warnings and precautions.  
Do not open the body of the device or otherwise attempt to service this device.  
Always store the device in a dry, well ventilated room.  
Keep the device away from any heating and air conditioning vents or other heating devices, direct sunlight, and moisture.  
Avoid dropping or otherwise shocking the unit. Although designed for rugged outdoor use, this device incorporates a sophisticated  
digital circuitry which could be damaged in extreme cases of misuse.  
Clean the optical lens with a professional lens cleaning supplies.  
Clean the exterior of the device with a soft clean cloth.  
Avoid removing the eyepiece as the LCD display could become damaged.  
Do not leave the device in direct sunlight or rain.  
Remove the batteries if the device will not be used for longer than a few weeks.  
For any other problems or questions, please contact Bushnell Customer Service at:  
(800) 423-3537 • www.bushnell.com  
 
5
TWO-Year LIMITED WARRANTY  
®
Your Bushnell product is warranted to be free of defects in materials and workmanship for two years after the date of  
purchase. In the event of a defect under this warranty, we will, at our option, repair or replace the product, provided that  
you return the product postage prepaid. This warranty does not cover damages caused by misuse, improper handling,  
installation, or maintenance provided by someone other than a Bushnell Authorized Service Department.  
Any return made under this warranty must be accompanied by the items listed below:  
1) A check/money order in the amount of $10.00 to cover the cost of postage and handling  
2) Name and address for product return  
3) An explanation of the defect  
4) Proof of Date Purchased  
5) Product should be well packed in a sturdy outside shipping carton, to prevent damage in transit, with return postage  
prepaid to the address listed below:  
IN U.S.A. Send To:  
Bushnell Outdoor Products  
Attn.: Repairs  
IN CANADA Send To:  
Bushnell Outdoor Products  
Attn.: Repairs  
8500 Marshall Drive  
Lenexa, Kansas 66214  
25A East Pearce Street, Unit 1  
Richmond Hill, Ontario L4B 2M9  
For products purchased outside the United States or Canada please contact your local dealer for applicable warranty  
information. In Europe you may also contact Bushnell at:  
Bushnell Germany GmbH  
European Service Centre  
Mathias-Brüggen-Str. 80  
D-50827 Köln  
GERMANY  
Tél: +49 221 995568-0  
Fax: +49 221 995568-20  
This warranty gives you specific legal rights.  
You may have other rights which vary from country to country.  
©2010 Bushnell Outdoor Products  
6
 
sPEcIFIcatIons  
Magnification:  
Objective Size:  
Battery Type:  
Viewing Range:  
Field of View:  
Operating Temperature Range:  
Dimensions:  
Weight:  
3x  
32 mm  
Two CR123 (3v, lithium) batteries (not included)  
1-328 ft. / .3-100m  
70 ft @ 100 yds / 23m @ 100m  
14-104 / -10 ~ 40 C (Humidity >90%)  
5.9 x 3.8 x 2.0 in. / 150 x 95 x 51 mm  
13.4 oz. /380g  
Tripod Mountable:  
Video Out:  
Yes  
NTSC video standard.  
Note: low ambient light operation may create low signal levels.  
6V DC, 1A, plug polarity=positive tip  
External AC Power Adapter:  
FCC Note:  
is equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. ese limits are designed  
to provide reasonable protection against harmful interference in a residential installation. is equipment generates, uses and can radiate radio frequency energy  
and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that  
interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined  
by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:  
· Reorient or relocate the receiving antenna.  
·
Increase the separation between the equipment and receiver.  
· Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.  
· Consult the dealer or an experienced radio/TV technician for help.  
Shielded interface cable must be used with the equipment in order to comply with the limits for a digital device pursuant to Subpart B of Part 15 of FCC Rules.  
NOTE: THE MANUFACTURER IS NOT RESPONSIBLE FOR ANY RADIO OR TV INTERFERENCE CAUSED BY UNAUTHORIZED MODIFICATIONS TO  
THIS EQUIPMENT. SUCH MODIFICATIONS COULD VOID THE USER AUTHORITY TO OPERATE THE EQUIPMENT.  
Specifications and designs are subject to change without any notice or obligation on the part of the manufacturer.  
7
 
©2010 Bushnell Outdoor Products  
(800) 423-3537 • www.bushnell.com  
 

Black Decker Food Processor HC20 User Manual
Bolens Lawn Mower 118 500A User Manual
Canon Digital Camera SUPER135 User Manual
Canon Scanner 220 User Manual
Carbine Stereo Receiver M9900DVDS User Manual
Cardo Headphones Scala 600 User Manual
Casio Digital Camera QV 5000SX User Manual
Cateye Heart Rate Monitor Heart Rate Computer User Manual
Chief Manufacturing Doll SSM 295 User Manual
Cisco Systems Network Card G01028 1E User Manual