Delfield Shelleymatic NDF User Manual

PROJECT

ITEM #

QUANTITY

APPROVAL

DATE

NDF

Mobile Drop-Front Self-Contained Milk or Beverage Dispensers

Short Form Specifications

Exterior sides, front and back shall be 20-gauge stainless steel.

Inner liner shall be water-tight and constructed of 22-gauge stainless steel

with a 1.25" (3.2cm) I.P.S. drain. Unit shall be insulated with high-density,

foamed in place polyurethane insulation with a non-conductive top breaker

strip.

Opening shall have stainless steel lift-up and fold-down lids with black

plastic recessed handles. Door lock is standard.

Ends of the upperstructure shall have die-stamped louvers to allow proper

air flow to the condensing unit.

Refrigeration system shall use HFC-134a refrigerant. Refrigerant flow shall

be controlled by an expansion valve. Cabinet shall maintain 36°F to 40°F

(2°C to 4°C) temperature with lids closed for storage.

Refrigeration system shall be controlled by a pressure control, located

near the condensing unit.

Electrical connections shall be 115 volt, 60 cycle, single phase. Unit shall

have a 9' (2.7m) long electrical cord and NEMA 5-15P plug.

Unit shall be mounted on (4) 4.00" (10.2cm) diameter polyolefin casters

(all locking), and shall have (4) non-marking grey bumpers, one at each

corner.

Model NDF-18

shown with optional wrap-around bumpers

Optional Accessories and Modifications

•

Heavy-duty casters (contact factory)

•

Wrap-around bumpers (adds 1.75" [4.4cm] to overall length and

depth)

•

Laminate panels

Fiberglass panels

Special voltages (contact factory)

NOTE: This equipment is intended for storage and /or display of pre-

packaged or bottled products only.